Ragged Edge Cedar Counter

The ragged edge cedar counter was a project to use up some leftover barn wood found in an old shed. The slats are trimmed to approx. 5″ wide. Then the boards were glued and clamped together side by side, while staggering the length of each. Then the end of the glued material was trimmed at 45° and glued to form a square edge. The matching wood grain aligns to give the appearance of wood folded to make a counter.

Clamping was a trick and several spring clamps were used to maintain an even line at the join. Vertical slat cedar with angle supports complete the farm look. No nails or screws are used. The piece is unfinshed, with only a light sand to remove slivers.

The ragged edge cedar counter is unnumbered and designed as an experiment to highlight the rustic appeal of an old fence or barn wall, knot holes included.