Wall Mounted Cedar Jewelry Case

This is a simple cedar slat box with a pine frame, cut in two, hinged, and mounted with two steel L-brackets. The L-brackets are mounted to a wall stud above and below the case. A small hole is drilled through the top and bottom of the case and two steel removeable pins secure the case to the brackets. Pull the pins and the case can be taken down and displayed on a flat surface.
The style is to be old farmhouse. All the surfaces are sanded smooth and there is no finish. The case will age and darken over time naturally. A simple gate latch holds the door.
Pegs were plotted on a pencil graph using a square. Two more cedar slats create a couple shelves. A detachable ring case rests inside. The dimensions are 63×24 cm (25″x 11″) and 17cm (6.75″) deep when closed.
Plumbing o-rings fit perfectly on 1/2″ dowel as a stop. The cedar slats are only 1/4″ thick so the 1.5″ pegs are cut at a 5° slope and glued in place. This keeps necklaces against the backboard.
The ring case uses 3/8″ dowels cut square and glued in place. A recycled picture stand is glued to the back and folds flat to tuck in a slat on the larger case.
The cedar is dry but still quite light in tone. Over the years the unfinished wood will age and start looking like a barn door. This piece is unnumbered and created as a fun test.

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.